Has swept chamber, vibration, mechanical bearing overheating and damage failure. Asynchronous motor, air gap between rotor is small, easy to cause, collision between the rotor. General because indoor end cover shaft hole wear or stop end cover mouth and base check mouth wear deformation, make the stand, end cover, single phase ac motor rotor misalignment caused chamber. Vibration should be distinguish is caused by the motor itself, or poor transmission device, or a mechanical load transfer, and then ruled out according to specific conditions. Belong to cause the vibration of the motor itself, mostly due to the rotor dynamic balance is not good, bad and bearing, shaft bending, or end cover, frame, rotor misalignment, or motor installation of foundation, installation does not reach the designated position, loose fasteners. Vibration can produce noise, will also generate additional load. Motor after electrify found speed to slow, analyze its reasons in many aspects, capacitor start motor capacity lack serious leakage, whether the capacitor voltage is too low, or a squirrel cage rotor article aluminum parts have a serious accident shrinkage cavity, breaks, and so three phase asynchronous motor on and so forth, especially the washing machine motor starting and positive and negative work alternately, often make article turned aluminum induced current big and make electromagnetic electricalmotor1.blogspot.com force increases, all can produce turned aluminum strip break, resulting in slow running to, serious when make the rotor fever and edm and burn winding lines).